Here’s the results of today’s mitreing. Pretty happy with the results so far. Just have the top tube to go and then into the more finicky work of the rear triangle. The main thing I learned today is that getting both sides of the mitres straight and level (ie. so the BB sits at exactly perpendicular) is much more important than getting the curves right. Sure getting the curves right is a good thing too, but it’s ok if there’s small gaps as it will allow the epoxy to fill into the inside of the tubing and strengthen the join.
- Heat treating bamboo
- Why not to buy a titanium bike frame
- Bamboo Bike #2 – The Daisy
- Choosing the bamboo for your frame
- bio-resins – alternatives to epoxy resin
- Bamboo Bike Frame Strength Test
- An all carbon bike?
- Foam & carbon
- Bamboo Bicycle Club Live Challenge – another great initiative!
- The progressing Panda